VIDEO

Informace

Ford

Ford P0001

See the basic definition of a diagnostic error. This will help you to clarify the main causes of the fault code. You will understand the program of the control unit
Basic DTC analysis according to OBD2 protocol standard.

OBD2 or On-Board Diagnostics displays messages for basic group styles. More comprehensible code composition has been standard since 2000. The DTC code consists of five characters and its composition will be shown in this video

Insight into programming

The basic unit for the operation of any computer is the bit. Logic 0 and 1 are expressed by a single bit. Diagnostics The error code is composed of 16 bits. The first two bits define one of the four basic circuits. The video will show you a comprehensive overview of the composition of the error report

A diagnostically understandable description of the Diagnostic Trouble Code

Ford P0001

Basic error definition

LOST COMMUNICATION WITH NOX SENSOR MODULE quot;A quot;

Cause of DTC

The aftertreatment system is equipped with two Nox Sensors. The upstream NOx Sensor 1 1 is located at the inlet elbow of the Diesel Exhaust Oxidation (DOC) Catalyst Diesel Particulate Filter (DPF) and is permanently connected (via a permanent wiring harness) to the NOx Sensor 1 1 Module mounted toward the front frame rail at the rear of the right front wheel well. The downstream NOx Sensor 1 2 is located at the outlet of the Selective Catalytic Reduction (SCR) Catalyst and is permanently connected (via a permanent wiring harness) to the NOx Sensor Module 1 2 mounted along the left middle frame rail. The upstream NOx Sensor 1 1 measures the NOx concentration upstream of the Catalysts. The downstream NOx Sensor 1 2 measures the NOx concentration downstream of the Catalysts. The NOx Sensors also perform a heater strategy. The NOx Sensor module monitors the sensor temperature and operates a heater inside the NOx Sensor probe to maintain proper sensor operating temperature. The NOx Sensors are smart devices and communicate with the Powertrain Control Module (PCM) over designated Data Link circuits. The NOx Sensors perform their own internal diagnostics and report malfunctions back to the PCM. The NOx Sensors are used to monitor the efficiency of the SCR Catalyst and dosing system. The PCM will illuminate the MIL lamp immediately after the monitor runs and fails.