VIDEO

Informace

Ford

Ford U0235

See the basic definition of a diagnostic error. This will help you to clarify the main causes of the fault code. You will understand the program of the control unit
Basic DTC analysis according to OBD2 protocol standard.

OBD2 or On-Board Diagnostics displays messages for basic group styles. More comprehensible code composition has been standard since 2000. The DTC code consists of five characters and its composition will be shown in this video

Insight into programming

The basic unit for the operation of any computer is the bit. Logic 0 and 1 are expressed by a single bit. Diagnostics The error code is composed of 16 bits. The first two bits define one of the four basic circuits. The video will show you a comprehensive overview of the composition of the error report

A diagnostically understandable description of the Diagnostic Trouble Code

Ford U0235

Basic error definition

SOLENOID CIRCUIT

Cause of DTC

Initially at power-up, then every 10 seconds thereafter. The solenoid circuits will also be tested immediately after a gear ratio or pressure switch error is detected. After three consecutive solenoid continuity test failures, or one failure if test is run in response to a gear ratio or pressure switch error. This DTC is strictly an electrical fault and cannot be caused by any internal transmission failure other than an open in the Transmission Solenoid TRS Assembly. If the Transmission Solenoid TRS Assembly is in need of replacement - do not replace the Valve Body