VIDEO

Informace

Mitshubishi

Mitshubishi C1219

See the basic definition of a diagnostic error. This will help you to clarify the main causes of the fault code. You will understand the program of the control unit
Basic DTC analysis according to OBD2 protocol standard.

OBD2 or On-Board Diagnostics displays messages for basic group styles. More comprehensible code composition has been standard since 2000. The DTC code consists of five characters and its composition will be shown in this video

Insight into programming

The basic unit for the operation of any computer is the bit. Logic 0 and 1 are expressed by a single bit. Diagnostics The error code is composed of 16 bits. The first two bits define one of the four basic circuits. The video will show you a comprehensive overview of the composition of the error report

A diagnostically understandable description of the Diagnostic Trouble Code

Mitshubishi C1219

Basic error definition

HO2S Heater (Bank 1 Sensor 2) Circuit High Input

Cause of DTC

Engine started, battery voltage must be at least 11.5v, all electrical components must be off, the ground between the engine and the chassis must be well connected, the exhaust system must be properly sealed between the catalytic converter and the cylinder head, the coolant temperature must be 80 degrees Celsius, and the oxygen sensor heater for oxygen sensor before the catalytic converter must be properly functioning. The DME detected the HO2S signal remained in a high state. The resistance is out of limits. The engine speed is less than 7008rpm (6208 for A T) and the exhaust temperatures are between 350.006 and 649.995 degrees Celsius. Note: The HO2S signal circuit may be shorted to the heater power circuit due to tracking inside of the HO2S connector. Remove the connector and visually inspect the connector for signs of oil or water.