VIDEO

Informace

Dodge

Dodge B1A68

See the basic definition of a diagnostic error. This will help you to clarify the main causes of the fault code. You will understand the program of the control unit
Basic DTC analysis according to OBD2 protocol standard.

OBD2 or On-Board Diagnostics displays messages for basic group styles. More comprehensible code composition has been standard since 2000. The DTC code consists of five characters and its composition will be shown in this video

Insight into programming

The basic unit for the operation of any computer is the bit. Logic 0 and 1 are expressed by a single bit. Diagnostics The error code is composed of 16 bits. The first two bits define one of the four basic circuits. The video will show you a comprehensive overview of the composition of the error report

A diagnostically understandable description of the Diagnostic Trouble Code

Dodge B1A68

Basic error definition

Cylinder 3 Misfire Detected

Cause of DTC

DTC P0010, P0011, P0016, P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0122, P0123, P0128, P0220, P0222, P0223, P0335, P0336, P0606, P0641, P0651, P1516, P2101, P2119, P2120, P2122, P2123, P2125, P2127, P2128, P2135, P2138, P2176, P3401, P3425, P3441, and P3449 are not set. The engine speed is between 375-5,800 RPM and DTC P0315 is not set. OR The engine speed is greater than 1,000 rpm and DTC P0315 is set. The ignition voltage is between 9-18 volts. The engine coolant temperature (ECT) is between -7 and +130°C (+19 and +266°F). If the ECT is less than -7°C (+19°F) at startup this diagnostic will not run until the ECT is more than +21°C (+69°F). The fuel level is more than 10 percent. The antilock brake system (ABS) and the traction control system (TCS) are not active or detecting rough road. Torque Converter Clutch (TCC) is not applied active. The power management is not active. The ECM is not in fuel shut-off, or decel fuel cut-off mode. Excessive drive wheel slip is not detected. The power take-off (PTO) is disabled; where applicable. The cylinder deactivation is not in progress; where applicable. A manual transmission with a throttle position less than 95 percent. DTCs P0300-P0308 run continuously when the above conditions are met.